handshake ==>
handshaking
1. Predetermined hardware or software activity designed to establish or maintain
two machines or programs in synchronisation. Handshaking often concerns the
exchange of messages or packets of data between two systems with limited
buffers. A simple handshaking protocol might only involve the receiver sending a
message meaning "I received your last message and I am ready for you to send me
another one." A more complex handshaking protocol might allow the sender to ask
the receiver if he is ready to receive or for the receiver to reply with a
negative acknowledgement meaning "I did not receive your last message correctly,
please resend it" (e.g. if the data was corrupted en route).
Hardware handshaking uses voltage levels or pulses on wires to carry the
handshaking signals whereas software handshaking uses data units (e.g. ASCII
characters) carried by some underlying communication medium.
Flow control in bit-serial data transmission such as EIA-232 may use either
hardware or software handshaking.
2. The method used by two modems to establish contact with each other and to
agreee on baud rate, error correction and compression protocols.
3. The exchange of predetermined signals between agents connected by a
communications channel to assure each that it is connected to the other (and not
to an imposter). This may also include the use of passwords and codes by an
operator.
[Jargon File]
(1995-01-13)
Nearby terms:
handle « hand-roll « handshake « handshaking
» handwave » hang » hanja
|
